×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerThis paper demonstrates experimental and numerical studies to investigate in perforation pipes with a phasing 180° and perforation densities 9 spm in a horizontal wellbore. The experimental study was conducted to investigate the phasing angle 180° in a horizontal wellbore. The wellbore has an inner diameter of 44 mm, as well as the length of the pipe is 2 m. For this purpose, a simulation model was created in the wellbore using the ANSYS FLUENT simulation software by using the standard k - e model and applied to the (CFD) with changing the axial flow from (40 - 160) lit/min and constant inflow through perforations from range (20 - 80) lit/min. Concerning the findings of this study, it was noticed that the total pressure drop (friction, acceleration, mixing) goes high as the total flow rate ratio increases. As well as, an increase of the inflow concerning the main flow rate ratio leads to an increase in the total pressure drop and a decrease in the productivity index. Furthermore, the percentage error of the total pressure drop between the numerical and experimental results in test 4 is about 5.4 %. Also, the average velocity goes high with increasing the total flow rates and the velocity keeps increasing along the length of the pipe until it reaches its maximum value at the end of the pipe due to the effect of the perforations. It was concluded that there are the numerical and experimental results reflected a good agreement concerning the study of the flow-through perforations at 180° angle in terms of pressure drop and apparent friction factor, etc.
There have been efforts and studies that have been carried out with respect to the flow patterns, pressure drops (PD), and void fraction (VF) that can be found in horizontal wells. Notwithstanding, particular attention has not been paid to research of two-phase flow (TFF) in perforated horizontal boreholes. Recently, a number of attempts have been undertaken to investigate the features of gas-liquid systems, which exist in a TFF in a perforated horizontal wellbore, which is a little studied tree of the wellbore family. The stated investigations are devoted to the TFF of liquid and gas in a horizontal wellbore, which has a diameter and length of $25.4~mm\times3$ m respectively, with 18 uniform perforations. In the developed Fluent VOF model integrated in ANSYS 22 R1, the turbulence treatment and flow conditions within three-dimensional space, including water and air, with various flow rates were used to study the influence of high water and air velocities (SVW, SVA) on flow characteristics including PD, production (Q), VF, and liquid retention time in a horizontal well. The sequences of slug flow (SF) phenomena have been studied in detail for this pulsated flow. In particular, the first scenario is where SVW can reach velocities of $1.22~m/s$ and SVA of $1.68~m/s;$ in the second scenario, an increase in the SVW to $2.52~m/s$ is noted; and in the last scenario, the value of SVA is increased to $2.2~m/s$. The empirical study was mainly targeted on the SF through a perforated horizontal wellbore. The productivity (Q), PD, and SF were found to benefit from an increase in axial flow rate (SVW), more than from increase in radial flow rate (SVA). In scenario two, productivity rises by even 84.108% as SVW changes, while in the last scenario Q increases by only 9.708% as SVA is increased. Further, the numerical and experimental results provide a reasonable match.