×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerConcerning commercial and residential buildings, one of the major parts related to water supply systems is the water storage tanks. For gravity- fed buildings, the tanks must be installed on the roof. In Iraqi summer, the temperature of water in storage tanks reaches above 50 °C due to high solar intensity, which makes it inappropriate for domestic usage. One of the proposed solutions to overcome this problem is feeding the hot water into an earth-water heat exchanger (EWHE) which consists of a set of buried pipes installed underground level to reduce its temperature. The storage tank and the earth-water heat exchanger were studied experimentally and theoretically by using ANSYS 20/FLUENT software to estimating the water temperature in the storage tank and the temperature of the water leaving the EWHE. The most important results obtained theoretically and experimentally that when using pipe length, pipe diameter, and mass flow rate of 100 m, 0.016 m, 0.7 LPM respectively, at a depth of 3 m, the water temperature decreases by about 15 °C. Also, the results have shown a good agreement between the experimental and theoretical works. One can conclude that an earth-water heat exchanger is an effective way to decrease the temperature of the storage water to an acceptable level for domestic usages.
Solar energy can only be used when it's sunny outside. Therefore, solar heating is only efficient during the day and decreases at night or on overcast days. Consumer energy needs have a distinct seasonal structure, and solar energy cannot completely meet those needs. In order to satisfy customer demand, energy storage is essential. In order to maximize the use of solar energy and to increase the energy and efficiency of the solar absorption system, superior thermal properties of sophisticated materials, such as phase change materials, are important [1]. In the current study, 20 kg of phase change material (PCM) is integrated with solar water heating and fed into a storage tank to enhance the solar water heating efficiency. Helical coil heat exchangers were added to the storage tank as an external load. The trials were conducted in four separate months (September 2021, April, May, and June 2022) that were chosen on the first day. The effectiveness, heat gain, and significance of the phase change material in increasing heating efficiency throughout the day were studied using a range of variables, including water volume flow rate (2, 3, 4, 6, and 8 L/min) and inlet water temperature (25, 30, and 35 °C). The results showed that, given an initial temperature of 25 °C, the daily efficiency range, was 0.58 to 0.65, and that the daily final outlet temperature was enhanced outlet temperature over 65 °C. Additionally, on all test days, the heat released by the phase change material was audible in the evening and increased the utilization time.
This study presents both experimental and theoretical investigations of an absorption refrigeration system using environmentally friendly working fluids, specifically the acetone–zinc bromide (Acetone/ZnBr₂) pair. The system was designed to operate under outdoor climatic conditions in Hilla City, Iraq, utilizing hot water as the heat source. Performance evaluation was carried out under various operating conditions, including changes in heat source, absorber, condenser, and evaporator temperatures. Experimental testing was conducted during September 2019. The results indicated that the coefficient of performance (COP) of the absorption cooling system ranged from 0.13 to 0.487, with an evaporator temperature drop of approximately 16 °C. Condensation and absorption temperatures remained below 41 °C, while the maximum driving water temperature reached 80 °C. A steady-state theoretical model was developed using the Engineering Equation Solver (EES) program, applying mass and energy balance equations to predict operating parameters such as temperature, pressure, and COP. Model predictions showed good agreement with the experimental measurements. Furthermore, the results confirmed that generator temperature has a significant influence on overall system performance.