×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerThe studying of fluid flow throughout fracture in the reservoir is one of the most vital subjects attracted much attention from engineers and geologists. In the present paper, the Dual Porosity-Dual Permeability (DPDP) model has been applied to represent the fluid flow within the fractured reservoirs. This work aimed to demonstrate the utility of the fractures in the petroleum reservoir and how could be used the positive effect of these fractures on the productivity as well. The productivity of single-phase fluid flow within the single horizontal fracture, multi horizontal fractures, and inclined fracture with different orientations (20 o , 30 o , 45 o , and 70 o ) have been implemented by using ANSYS- CFX program and compared with the productivity of conventional (without fractures) reservoirs. In addition to, visualize the velocity streamlines within fracture and matrix zones for the DPDP model. To verify this work the comparison has been made with published paper, which studies the fluid flow through fractures, and a good agreement has been obtained with each other. The study indicates that the presence of macro scale fractures in petroleum reservoirs contributes to increasing the total productivity of these reservoirs. Clearly, the productivity index of multi-horizontal fractures domain is more than twice of nonfractured domain. It is also clear that, when comparing the fractured and nonfractured reservoir, the improvement percentage of the productivity index reaches to (71.8) for a single horizontal fracture with 9 ft length. While this percentage would be about (116.88) if the fracture is inclined with 20 o .
Corrugated plates play very important role in various engineering applications. The occurrence of crack in the body of corrugated plate might results in catastrophic failure. In the present paper there are different profiles of corrugated plates (trapezoidal, sinusoidal and triangle) that are studied. In each profile the stress intensity factor and shape factor were calculated for various crack orientations, various corrugation angles and different curvature radius for the same profile. They are all subjected to different loading conditions using Extended Finite Element Method (XFEM). It is found the stress intensity factor when load applied parallel to corrugation direction is higher when load applied perpendicular to corrugation direction. Also found that the stress intensity factor increase by 115% when curvature radius increases with the load applied perpendicular to corrugation. This study also found and explained that the stress intensity factor increases slightly when the corrugation angle of triangle corrugated plate increases. In all cases studied, the trapezoidal corrugated plate shows the lower values of stress intensity factor compared to the sinusoidal and triangle corrugated plates.