×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerVan Kármán vortex street is considered an important phenomenon that accompanies fluid flow, especially when exposed to a certain barrier, as periodic vortexes occur on both sides of the body that rotate in two opposite directions. This phenomenon occurs in the atmosphere around mountains, oceans, seas, and islands. Also, this phenomenon makes it possible to induce a fluid flow around a specific body present in the flow path. In this study, a model for fluid flow around a cylinder of a certain diameter was taken, where the flow near the boundary layers of the cylinder surface moves slower than near the free stream. In addition, the pressure distribution was studied, and it was observed that there is a pressure gradient due to the difference in momentum at the surface of the cylinder in distant areas due to friction. The study area was divided into fine meshes with Fluent software, especially in the irregular areas. The simulation was implemented for Reynolds numbers Re = 100 and Re = 1500 for incompressible flows. Consequently, the equations that do not depend on pressure are difficult to solve. Therefore, methods linking pressure and velocity were adopted, where the pressure-velocity coupling simple method was used. The first-order forward difference scheme was adopted in representing the differential equations as a function of time when performing the simulation. From the steady state and upwards to Reynolds number Re = 100, it was observed that a twain of vortices appeared on the body at a certain speed range. When the state was changed from the stable state to the transitional state, the results changed, as the flow became asymmetric and unsteady due to vortex shedding phenomena, which led to the generation of vortexes in different ways. The U-Velocity curve was studied for two different cases, and the results showed a large discrepancy between the first order and the second order, where the second order had better behavior but required great effort to reach accurate results. Also, pressure-velocity was studied to satisfy mass conservation, and numerical techniques were used to c ompute the equations of Navier-Stokes in CFD, such as SIMPLEC, PISO, and SIMPLE. An acceptable convergence was not reached with the PISO; therefore, the SIMPLE method was adopted. The pressure gradient was drawn around the cylinder, where it was observed that the pressure was greatest at the front of the cylinder and its lowest value at the end.
Continuously Variable Transmission (CVT) combines the efficiency of manual transmissions with the driving comfort of automatic transmissions while providing an infinite range of gear ratios, improved fuel economy, and enhanced acceleration performance. This study presents a comparative evaluation of CVT performance against manual and automatic transmissions in a parallel hybrid electric vehicle (HEV), focusing on fuel consumption and exhaust emissions. A baseline HEV model equipped with a CVT gearbox was selected from ADVISOR simulation software and subsequently modified by replacing the CVT with manual and automatic transmissions for comparison. Exhaust emissions, including catalytic converter pollutant reactions, were recorded for all configurations. Performance assessments were conducted using several global standard driving cycles to simulate real driving conditions. Results indicated that the CVT configuration achieved superior fuel economy and a significant reduction in exhaust emissions compared with manual and automatic transmissions. This improvement is attributed to the CVT’s effective control of speed ratio and overall transmission efficiency. The findings support the suitability of CVT gearboxes for urban hybrid vehicle applications due to their low fuel consumption and high efficiency in speed ratio control.