Cover
Vol. 24 No. 1 (2024)

Published: February 29, 2024

Pages: 97-108

Original Article

Performance Evaluation of Single Stage Flash Evaporation Desalination Unit Integrated with a Parabolic Trough Solar Collector for Basrah City Climate, Iraq

M. Kareem Salim 1 Hussien S. Sultan 2 Falah A. Abood 2
1 General Company for Ports of Iraq (GCPI), Department of Shipyard and Marine Industries, Basrah, Iraq
2 Department of Mechanical Engineering, College of Engineering, University of Basrah, Basrah, Iraq
History
  • Received: December 11, 2023
  • Revised: February 5, 2024
  • Accepted: February 14, 2024
  • Available Online: February 15, 2024
DOI

https://doi.org/10.33971/bjes.24.1.11

Abstract

Solar energy is the most suitable among all renewable energy options for competing with fossil fuels in desalination due to its ability to utilize both heat and power for the process. In this study, the Parabolic Trough Solar Collector (PTSC) for powering a Single Stage Flash (SSF) desalination unit was proposed for Basrah city climate, Iraq. The desalination system comprises two directly coupled sub-systems: the PTSC and the SSF desalination unit. The preheated feed brine water coming from condenser was used as a Heat Transfer Fluid (HTF) for PTSC, which gets heated to a desired temperature referred to as the Top Brine Temperature (TBT). The numerical simulations were performed via EBSILON professional 16.02 (2022) software. The effects of TBT, mass flowrate of feed brine water to get the desired TBT, solar collector area, and vacuum pressure inside flash chamber on the performance of the desalination system was studied. A major finding of the current study can be summarized as follows: The collector efficiency is enhanced eventually as TBT increases. The maximum values of distillate water in June are around 5.5, 4.56, 3.69, 2.75 and 1.85 kg/h for 12.408, 10.434, 8.3472, 6.26, and 4.1736 m² collector area respectively, when TBT 107 °C and vacuum pressure 40 kPa. For 1.598 m² collector area, the total distillate in the 1st of June amounted to 7.9 kg, with an average production rate of around 0.7 kg/h. The solar SSF system's productivity per solar collector unit area at 20 kPa, 15 kPa, and 10 kPa vacuum pressures was 4.7 kg/day/m², 5.3 kg/day/m², and 6.25 kg/day/m², respectively. The average Performance Ratio (PR) values are determined to be 0.694, 0.577, and 0.491 for 10 kPa, 15 kPa, and 20 kPa, respectively. These results are very acceptable when compared with an existing literature.

Keywords

References

  1. M. A. Darwish, S. G. Serageldin, and H. T. Eldessouky, “Flashing in desalination units,” Desalination, vol. 19, no. 1, pp. 93-101, 1976.
  2. M. Farwati, “Theoretical study of multi-stage flash distillation using solar energy,” Energy, vol. 22, no. 1, pp. 1-5, 1997.
  3. J. Joseph, R. Saravanan, and S. Renganarayanan, “Studies on a single-stage solar desalination system for domestic applications,” Desalination, vol. 173, no. 1, pp. 77-82, 2005. https://doi.org/10.1016/j.desal.2004.06.210
  4. A. S. Nafey, M. A. Mohamad, S. O. El-Helaby, and M. A. Sharaf, “Theoretical and experimental study of a small unit for solar desalination using flashing process,” Energy Conversion and Management, vol. 48, no. 2, pp. 528-538, 2007. https://doi.org/10.1016/j.enconman.2006.06.010
  5. S. C. Maroo, and D. Y. Goswami, “Theoretical analysis of a single-stage and two-stage solar driven flash desalination system based on passive vacuum generation,” Desalination, vol. 249, no. 2, pp. 635-646, 2009. https://doi.org/10.1016/j.desal.2008.12.055
  6. K. S. Reddy, K. R. Kumar, T. S. O'Donovan, and T. K. Mallick, “Performance analysis of an evacuated multistage solar water desalination system,” Desalination, vol. 288, pp. 80-92, 2012.
  7. M. Al-Hamahmy, H. E. S. Fath, and K. Khanafer, “Techno-economical simulation and study of a novel MSF desalination process,” Desalination, vol. 386, pp. 112, 2016. https://doi.org/10.1016/j.desal.2016.02.018
  8. Y. Roy, G. P. Thiel, M. A. Antar, and J. H. Lienhard, “The effect of increased top brine temperature on the performance and design of OT-MSF using a case study,” Desalination, vol. 412, pp. 32-38, 2017.
  9. M. Alsehli, J.-K. Choi, and M. Aljuhan, “A novel design for a solar powered multistage flash desalination,” Solar Energy, vol. 153, pp. 348-359, 2017.
  10. K. Garg, V. Khullar, S. K. Das, and H. Tyagi, “Performance evaluation of a brine-recirculation multistage flash desalination system coupled with nanofluid-based direct absorption solar collector,” Renewable Energy, vol. 122, pp. 140-151, 2018.
  11. I. Darawsheh, M. D. Islam, and F. Banat, “Experimental characterization of a solar powered MSF desalination process performance,” Thermal Science and Engineering Progress, vol. 10, pp. 154-162, 2019.
  12. M. Alsheekh, S. E. Najim, and H. S. Sultan, “Experimental, Theoretical and CFD Validations for Solar Powered Atmospheric Water Generation Using Thermoelectric Technics,” Basrah journal for engineering science, vol. 21, no. 2, pp. 17-28, 2021.
  13. H. Jassim Jaber, Q. A. Rishak, and Q. A. Abed, “Using PCM, an Experimental Study on Solar Stills Coupled with and without a Parabolic Trough Solar Collector,” Basrah journal for engineering science, vol. 21, no. 2, pp. 45-52, 2021. https://doi.org/10.33971/bjes.21.2.7
  14. M. Alsehli, “Experimental Validation of a Solar Powered Multistage Flash Desalination Unit with Alternate Storage Tanks,” Water, vol. 13, no. 16, 2021.
  15. A. Babaeebazaz, S. Gorjian, and M. Amidpour, “Integration of a Solar Parabolic Dish Collector with a Small-Scale Multi-Stage Flash Desalination Unit: Experimental Evaluation, Exergy and Economic Analyses,” Sustainability, vol. 13, no. 20, 2021.
  16. A. K. Thakur, R. Sathyamurthy, R. Velraj, I. Lynch, R. Saidur, A. K. Pandey, S. W. Sharshir, Z. Ma, P. GaneshKumar, and A. E. Kabeel, “Sea-water desalination using a desalting unit integrated with a parabolic trough collector and activated carbon pellets as energy storage medium,” Desalination, vol. 516, 2021.
  17. F. Farhadi, M. Deymi-Dashtebayaz, and E. Tayyeban, “Studying a Multi-Stage Flash Brine Recirculation (MSFBR) System Based on Energy, Exergy and Exergoeconomic Analysis,” Water, vol. 14, no. 19, 2022.
  18. Q. Thabit, A. Nassour, and M. Nelles, “Water Desalination Using the Once-through Multi-Stage Flash Concept: Design and Modeling,” Materials (Basel), vol. 15, no. 17, Sep 3, 2022.
  19. J. Duffie, and W. J. D. Beckman, William A. Beckman, Wiley: Solar Engineering of Thermal Processes, John A. 2013.
  20. S. A. Kalogirou, Solar energy engineering: processes and systems: Academic Press 1st Edition, 2013. ISBN 978-012-374501-9
  21. E. Bellos, C. Tzivanidis, K. A. Antonopoulos, and I. Daniil, “The use of gas working fluids in parabolic trough collectors – An energetic and exergetic analysis,” Applied Thermal Engineering, vol. 109, pp. 1-14, 2016.
  22. G. Coccia, G. D. Nicola, and A. Hidalgo, Parabolic Trough Collector Prototypes for Low-Temperature Process Heat (Springer Briefs in Applied Sciences and Technology). 2016.
  23. G. W. Treadwell, Design considerations for paraboliccylindrical solar collectors, Sandia National Lab. (SNLNM), Albuquerque, NM (United States), 1976.
  24. H. El‐Dessouky, H. I. Shaban, and H. Al‐Ramadan, “Multi‐stage flash desalination process: A thermal analysis,” Developments in Chemical Engineering Mineral Processing, vol. 4, no. 1‐2, pp. 5-22, 1996.
  25. V. Dudley, G. Kolb, M. Sloan, and D. Kearney, “SEGS LS2 solar collector test results, Report of Sandia National Laboratories,” SANDIA94-1884, USA, 1994.